Ignite Petite by Jon Renau | Synthetic Lace Front Wig | Basic Cap

Jon Renau HD | Heat Defiant Care

Jon Renau Recommends Washing Your Alternative Hair Every 6-8 Wears

CLEANSE & CONDITION

• Before washing, gently remove any tangles using your Wide Tooth Comb
• Wet hair completely using cool running water, allowing the water to flow in the direction of the fibers
• Gently lather the hair with a small amount of Jon Renau Synthetic Shampoo, making sure that the hair is traveling in the same direction
• DO NOT rub hair as this will cause tangling
• Rinse thoroughly under cool running water until water runs clear
• Wrap wig or hairpiece in a towel and gently pat dry
• Spray fibers with Jon Renau Leave-In Conditioning Spray (3-5 pumps) keeping away from base of wig or hairpiece
• Do not rinse out conditioner
• Gently detangle hair using your Wide Tooth Comb

DRY & STYLE

• Allow wig or hairpiece to air dry naturally by placing on a plastic or wire wig stand
• Air drying your wig will give the best results
• The fiber will dry fastest; be sure the cap is completely dry before styling, wearing, storing, or displaying
• DO NOT blow dry Synthetic hair or Heat Friendly Synthetic fibers
• For mid-length to long-length styles, apply HD Smooth Detangling Spray (3-5 pumps) focusing on the bottom half of wig or hairpiece
• Gently comb through using your Wide Tooth Comb only
• Other tools will cause frizzing/tangling
• HD fiber can withstand heat up to 350° F; however, Jon Renau recommends working at 270°-280° F
• It is recommended to use professional grade heat styling tools with digital temperature settings to control heat

CURL & FLAT IRON

• Heat your curling or flat iron to 270°-280° F
• Using your Jon Renau Wide Tooth Comb, gently comb hair free of tangles
• Starting at the nape, take ½ inch to 1 ½ inch sections of hair (smaller sections = tighter curls, larger sections = looser curls)
• Spray Heat Treat Thermal Spray on the section to protect the fiber (1-2 pumps per section)

CURL

• Gather hair into curling iron, smooth through to the ends. Roll iron up towards base of wig or hairpiece, staying 1 to 2 inches away from the base
• Hold for 10-15 seconds, then turn the tip of iron toward the ground and release curl into palm of hand
• Holding curl in one hand, gather up towards base and secure curl with a small metal clip (like a pin curl)
• Allow curl to cool completely (about 5 minutes); remove clip and let curl hang naturally

FLAT IRON

• Starting at the nape, take ½ inch to 1 ½ inch sections
• Spray Heat Treat Thermal Spray on the section to protect the fiber (1-2 pumps per section)
• Slowly smooth flat iron down through ends; keep hair smooth by following behind the flat iron with your Wide Tooth Comb
• Allow hair to hang naturally and cool completely

TIPS

• All synthetic fibers can tangle and frizz with wear
• It is important that the frizz is corrected early to avoid permanent damage to the fiber
• Use your flat iron to smooth any frizz before washing
• We recommend using HD Smooth Detangling Spray with a Wide Tooth Comb DAILY to detangle your HD wig or topper
• This is especially important with the mid-length to long-length HD wigs or hairpieces
• To add texture and definition, use a small amount of Piece Out Contour Fiber Crème and apply using fingertips