Vienna Roast E by Belle Tress | HF Synthetic Lace Front Wig | Mono Part

For Belle Tress Heat-Friendly Synthetic Wigs

1. Wash

• Use a wide tooth comb to remove any tangles.
• Hold your wig or hair topper under the faucet using cool water and let the water flow in the direction of the hair fibers. 
• Use a small amount of Belle Tress Salon Shampoo and gently lather the fibers and the cap to remove any dirt or build-up. Do not rub, twist, or scrub the fibers. 
• Rinse thoroughly in cool running water.
• Gently pat dry with a towel (do not wring or squeeze).
  

2. Condition

• Apply BelleTress Salon Coat Conditioner as directed and rinse with cool running water. Avoid applying conditioner directly to the roots or knots.
  
• Once rinsed, pat the wig or topper dry using a towel.
• Place the wig on a plastic wig stand to air dry completely. Do not dry on a solid block head, as this may stretch the cap and prevent necessary air-flow to dry the cap.

3. Finish

• Use BelleTress Salon Hold Holding Spray for light hold, definition, or touch-ups.
• Allow the fiber to settle naturally for the most realistic finish.

Step-by-Step Instructions for Styling Your Belle Tress Wig or Hair Topper

BelleTress heat-friendly synthetic fiber allows you to curl, straighten, and restyle within safe temperature limits. Follow these guidelines to protect your wig and keep it looking beautiful.

1. Recommended Heat Range

• 250°F–300°F (121°C–149°C) is the ideal safe range.

• Do NOT exceed 300°F (149°C) — higher heat may permanently damage the fiber.

2. Before Styling

• Make sure the wig is 100% dry. Never apply heat to damp fiber.

• Gently detangle using a wide-tooth comb.

• Place the wig or topper on a collapsible wig stand or styling head (avoid stretching).

• Apply a heat-protectant spray specifically formulated for synthetic hair to the fibers.

3. Curling Belle Tress Wigs

1. Set your curling iron/wand to 250–300°F.

2. Work in small sections.

3. Wrap hair gently around the barrel—avoid tight pulling.

4. Hold for 5–8 seconds, then release.

5. Allow curls to cool completely in place to “set” the new style.

Pro Tip: Pin curls while cooling for longer-lasting shape.

4. Straightening Belle Tress Wigs

1. Use a flat iron set between 250–300°F.

2. Glide smoothly from roots to ends—avoid clamping tightly.

3. Make one slow pass at a time.

4. Let the hair cool naturally before touching or brushing.

5. Adding Volume

• Use a round brush + low heat (below 300°F).

• Focus on the mid-lengths for soft lift.

• Tease gently at the root if more volume is desired—Belle Tress fibers respond well to light teasing.

6. After Styling

• Once cooled, lightly comb or finger-style to blend.

• Lock in shape with Belle Tress Salon Hold Holding Spray if desired.

• Avoid heavy or oily products—they can weigh down synthetic fibers.

7. Important Heat-Friendly Synthetic Fiber Notes

• Do not use steamers or boiling water methods.

• Keep wigs away from open ovens, grills, and high-heat environments.

• Store the wig on a collapsible wig stand to maintain cap shape.

• Heat-friendly fiber doesn’t “bounce back”—once restyled, the new shape remains until heat is applied again.

We recommend using products in available in the Essential Wig Care Kit by Belle Tress.